Voskan Auto Diagnostic

Connect via CAN bus 100 – Directly connection to CAS2 or CAS3 via CAS connector
Connect with New Body BMW vehicles - E6X, E7X, E9x via OBDII
Connect with Old Body BMW vehicles - E3x, E5x, E8x, R4x, R5x, L3x via OBDII or Circle connector
Reading of DTCs (standard, history and shadow error memory of the modules)
Clearing of DTCs (standard, history and shadow error memory of the modules)
Entering in logistic mode of the modules in the vehicle
Leaving from logistic mode
Synchronization of the engine control module and car access system module
Synchronization DME/DDE and EWS3/EWS4
Enabling / Disabling of a key
ENABLE/DISABLE of TV function for E38 E39 E46 E53 E83 E85
Read and change KM inside EGS - Electronic Gear System
Read and change KM inside EGS - Electronic Gear System
Read and change KM inside VTG - Transfer Box
Read and change KM inside ABS - Antilock Braking System
Read KM from IKE, LCM, EWS, ECU
Resetting service intervals

Programming identification of the modules in the vehicle
Programming User Information Fields in the electronic modules
Read / Write of memory of the electronic control modules
READ/WRITE eeprom from CAS1 (E65) via OBDII
READ/WRITE eeprom from CAS2 and CAS3 via dash connector or CAS connector, read/write km
Programming odometer value in the CAS module (Information about enabled/disabled keys. Key cutting code)
Programming key and remote control data in the CAS
Direct programming key/transponder with the help of a programmer associated with software
* Not granted for all type of control modules.
Read / Program VEHICLE ORDER DATA by OBDII. You can easily add new modules to the vehicle (like xenon lights and etc.). You can easily remove units from the vehicle so will be easy later to reprogram the FLASH memory of the elctronic control units independently and the existing vihicle configuration will not meet requirements for the SSS/Progman programming.
Program keys by OBDII - CAS2 systems (free update for BN003)
Program milleage by OBDII - CAS2 systems (free update for BN003)
Reading flash memory from engine control units by OBDII (BOSCH EDC16x, BOSCH DDE4, BOSCH BMS46, SIEMENS MS41 /MS42 /MS43/ MS50/MS52/MS54, BOSCH ME7)
New user interface for programming of keys CAS1/CAS2/CAS3
Reading/writing CAS3 by OBDII. Programming keys and Remote control by OBDII for BMW vehicles equipped with CAS3 module with the help of the Hi Tag 2 programmer, connected together with the BMW Commander to the Laptop!